H-bridge using IR2184 chip.

Thread Starter

MrsssSu

Joined Sep 28, 2021
266
1647530260591.png
1647530376972.png
Hi all, I want to implement a H-bridge driver circuit. May I know how to make some changes to the circuit above so that it forms a full-H-bridge using transistors. I attached my LT Spice file below :) Thank you for reading.
 

Attachments

crutschow

Joined Mar 14, 2008
34,282
You just duplicate the complete circuit for the other two transistors.

For a 0.2ms period signal, C1 has to provide the current the transistor base through R1, so the C1R1 time-constant should be at least 10 times that period or 2ms.
This gives a C1 value of of 2ms / 5k = 400nF.
I would use at least 1µF.
 

Thread Starter

MrsssSu

Joined Sep 28, 2021
266
You just duplicate the complete circuit for the other two transistors.

For a 0.2ms period signal, C1 has to provide the current the transistor base through R1, so the C1R1 time-constant should be at least 10 times that period or 2ms.
This gives a C1 value of of 2ms / 5k = 400nF.
I would use at least 1µF.
1647532881884.png
Hi sir, is this correct? I get a really bad output at R4 :(
 

ronsimpson

Joined Oct 7, 2019
2,988
Look at Q4. Its input Base or Gate is at near 0V all the time. But it is tied to the input of Q1 who's Base or Gate goes from 0V to 20+15V. (if it has a Gate) or 0 to 20+0.7 for a Base.
 
Top