Hi guys,
I’m a trainee in motor rewinding, due to furlough I’ve been pretty much working on my own the last 4 months so trying to teach myself to some success but also becoming stuck as I am now. I have an old Woods of Colchester 60slot single phase 8pole perm cap 220/240 volt fan motor. It’s a vc37029 type.
I traced the connections and miked the leads and found that the z winding is size 0.450 whilst the a winding is 0.475. However whilst I was counting the turns I noticed that on one set of the coils it looked smaller and on measuring the wire found it to be 0.400. Problem is I have no idea where it goes or came from as I have stripped the stator and the crown was destroyed on removal.
My question is; What effect will winding the motor with only the two sizes of wire I found off the leads would it have on the motor? If possibly four of the eight coils on either the start or the run is 0.400 and I wind it with either 0.450 or 0.475, increasing the cross sectional area, would I still achieve the desired rpm or will it affect that as well as the current? And also, is it possible?
Also these were quite common back in the day so if someone has any winding details it would be much appreciated. It’s a long shot but I’m stuck...attached
TIA
H
I’m a trainee in motor rewinding, due to furlough I’ve been pretty much working on my own the last 4 months so trying to teach myself to some success but also becoming stuck as I am now. I have an old Woods of Colchester 60slot single phase 8pole perm cap 220/240 volt fan motor. It’s a vc37029 type.
I traced the connections and miked the leads and found that the z winding is size 0.450 whilst the a winding is 0.475. However whilst I was counting the turns I noticed that on one set of the coils it looked smaller and on measuring the wire found it to be 0.400. Problem is I have no idea where it goes or came from as I have stripped the stator and the crown was destroyed on removal.
My question is; What effect will winding the motor with only the two sizes of wire I found off the leads would it have on the motor? If possibly four of the eight coils on either the start or the run is 0.400 and I wind it with either 0.450 or 0.475, increasing the cross sectional area, would I still achieve the desired rpm or will it affect that as well as the current? And also, is it possible?
Also these were quite common back in the day so if someone has any winding details it would be much appreciated. It’s a long shot but I’m stuck...attached
TIA
H
Attachments
-
144.6 KB Views: 12