How does LTspice search for symbols and subcircuits? Is it different for automatically generated symbols and Out of the box symbols? I ask because I ran into an error message that states "Could not open library file "C:\users\*****\Documents\***etc". This was when I tried to run a new project with the sub circuit and symbol stored in the LTsice folder generated during the LTsice install and the model was downloaded from KSIM. The key here is that LTspice is looking in a completely different folder. Instead LTspice looks in in a much older project that also used this part. At the time I saved the third party part in the same folder as the project rather than the LTspice folders.
I have since tried to remedy the problem by deleting the subcircuit model from the old project file and adding file paths in the LTspice control panel to redirect LTspice, but none of this has had an affect.
I have since tried to remedy the problem by deleting the subcircuit model from the old project file and adding file paths in the LTspice control panel to redirect LTspice, but none of this has had an affect.