I built a trolling motor for my kayak using this motor.
SSS 56114 360KV Brushless 1/5 Motor 13.000W 56114mm for Boat, car and Surfboard Maximum Amps: 95A Max volt: 125V.
and this ESC.
SPECS 300A BOAT ESC Flier mod. R-Snake Voltage (LiPo): 3-12S Voltage: 12V to 50V Anti-spark cable: yes Wires: 8AWG Connectors: 8mm Bullet BEC: No Size (mm): 2405735 Weight: 387g
The ESC shuts down after a few seconds, after I throttle down I can run it again almost immediately,
it will run for a few more seconds then quit again. The ESC and motor do not get hot at all Everything is connected well with 8 gauge wire I'm using a 6s 8p battery.
I have tested all the cells individually under load, all good. When I put the amp meter on it at full throttle with the prop in water it only draws about 2 amps.
the voltage drops from 24.4 to 23.9.
I have gone through all the settings in the firmware, the low voltage cutoff is at 19.2v This is supposed to be a 300 amp ESC
Which ESC, or what else do I need to get to make this work?
If the battery is only dropping .5v at full throttle and full load and it only draws 2 amps, it must be the ESC correct?
Battery- 6s 8p
SSS 56114 360KV Brushless 1/5 Motor 13.000W 56114mm for Boat, car and Surfboard Maximum Amps: 95A Max volt: 125V.
and this ESC.
SPECS 300A BOAT ESC Flier mod. R-Snake Voltage (LiPo): 3-12S Voltage: 12V to 50V Anti-spark cable: yes Wires: 8AWG Connectors: 8mm Bullet BEC: No Size (mm): 2405735 Weight: 387g
The ESC shuts down after a few seconds, after I throttle down I can run it again almost immediately,
it will run for a few more seconds then quit again. The ESC and motor do not get hot at all Everything is connected well with 8 gauge wire I'm using a 6s 8p battery.
I have tested all the cells individually under load, all good. When I put the amp meter on it at full throttle with the prop in water it only draws about 2 amps.
the voltage drops from 24.4 to 23.9.
I have gone through all the settings in the firmware, the low voltage cutoff is at 19.2v This is supposed to be a 300 amp ESC
Which ESC, or what else do I need to get to make this work?
If the battery is only dropping .5v at full throttle and full load and it only draws 2 amps, it must be the ESC correct?
Battery- 6s 8p