Whatever sketch I open or create, from whatever source, it fails to upload with a whole raft of errors. Here's an extract of them:
System wide configuration file is "C:\Program Files (x86)\Arduino\hardware\tools\avr/etc/avrdude.conf"
Using Port : COM3
Using Programmer : arduino
Overriding Baud Rate : 115200
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xc6
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0xc6
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0xc6
etc
I studied this link:
Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.
but found no solution. I read several posts about this but most replies were over my head.
I'm an Arduino novice and I'd appreciate any help please.
The most puzzling thing is that I HAVE successfully run this sketch before on another PC. But retrying today that gave me the same frustrating result!
Terry, East Grinstead, UK
System wide configuration file is "C:\Program Files (x86)\Arduino\hardware\tools\avr/etc/avrdude.conf"
Using Port : COM3
Using Programmer : arduino
Overriding Baud Rate : 115200
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xc6
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0xc6
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0xc6
etc
I studied this link:
Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.
but found no solution. I read several posts about this but most replies were over my head.
I'm an Arduino novice and I'd appreciate any help please.
The most puzzling thing is that I HAVE successfully run this sketch before on another PC. But retrying today that gave me the same frustrating result!
Terry, East Grinstead, UK