Could anyone provide me the knowledge on how to design the pads for this connector with special mark on point 7.
How to handle the Shaded region in this design.
1. Is that need to be considered as a pad? (or)
2. Shaded region is no need to consider as a part in footprint? (or)
3. Shaded part is a Pad but need to be pasted with solder mask or any other way?
I'm designing in KiCad.
How to handle the Shaded region in this design.
1. Is that need to be considered as a pad? (or)
2. Shaded region is no need to consider as a part in footprint? (or)
3. Shaded part is a Pad but need to be pasted with solder mask or any other way?
I'm designing in KiCad.
