orcad

  1. N

    Covering mounting holes in copper pour in Cadence Allegro/PCB Editor

    Hi, I am trying to get the mounting holes covered in the copper pour but I am not sure what would be the best way to do that. Is using the shape edit to manually edit the shape of the copper pours the only way? Any advice would be appreciated.
  2. 7

    What should be connected to the 5th pin of transformer?

    Hello, I'm an electronics engineering student, currently trying to design a circuit that includes a transformer. I'm using Orcad's Capture (Pspice) software. When I searched "Transformer", this part appeared as 'Generic Transformer', the part name goes by 'PWMXFM'. It has 5 connections, I...
  3. P

    PCB Design: Footprint creation for Connector Molex Part 5024301430

    Could anyone provide me the knowledge on how to design the pads for this connector with special mark on point 7. How to handle the Shaded region in this design. 1. Is that need to be considered as a pad? (or) 2. Shaded region is no need to consider as a part in footprint? (or) 3. Shaded part is...
Top