Hi all,
A while since I've posted on here! I've been working on a project that is nearly finished except, I haven't found a way I'm happy with to charge it, its a small wrist mounted device with a lipo battery and associated charging circuit.
I've a ftdi chip for usb/serial and to decide if it can charge from USB.
Its mounted in a okw box and I've tried to find a good way to mount a micro USB socket but as it for use in agriculture I want it as water tight as possible.
I've seen USB memory sticks that have a bit of PCB as the USB plug, I could extend my PCB outside the enclosure and use it as a plug? Anyone done this? Are there good reasons not too?
Cheers Geoff
A while since I've posted on here! I've been working on a project that is nearly finished except, I haven't found a way I'm happy with to charge it, its a small wrist mounted device with a lipo battery and associated charging circuit.
I've a ftdi chip for usb/serial and to decide if it can charge from USB.
Its mounted in a okw box and I've tried to find a good way to mount a micro USB socket but as it for use in agriculture I want it as water tight as possible.
I've seen USB memory sticks that have a bit of PCB as the USB plug, I could extend my PCB outside the enclosure and use it as a plug? Anyone done this? Are there good reasons not too?
Cheers Geoff