Trying to use MCP4261, few questions need help

Thread Starter

LAOADAM

Joined Nov 21, 2018
862
Need detail explanation about:
1. SHDN pin12 and sketch config, how to ignore SHDN cause of only one piece?
2. same as above of the CS pin1?
3. how to wiring wp pin11?

Thanks
 

TeeKay6

Joined Apr 20, 2019
573
Need detail explanation about:
1. SHDN pin12 and sketch config, how to ignore SHDN cause of only one piece?
2. same as above of the CS pin1?
3. how to wiring wp pin11?

Thanks
What parts of the Microchip datasheet do you not understand? (Pls give paragraph numbers & figure numbers.) Your question #1 is unclear to me; are you asking whether you can shut down only one half of a dual pot device?
 

DickCappels

Joined Aug 21, 2008
10,152
SHDN pin12 and sketch config, how to ignore SHDN cause of only one piece?

Tie SHDN high.

same as above of the CS pin1?

Ground this pin.

how to wiring wp pin11?

Tie this one high.
 
Top