All About Circuits

TE- BNC Connector - Pin Description for PCB

O

Thread Starter

or789

Joined Oct 15, 2019
20
Hi,
I am using TE Connectivity Right Angle 50Ω PCB Mount Fitting BNC Connector for signal output in a PCB Board.
It contains 2 Pins. Is Pin 1 for Signal and Pin 2 for ground?
Also, do I need to add any protectors(EMC, Etc...) inboard for this.
Thanks in advance



1587932108168.png
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Y problem finding footprint for a connector in ALtium PCB Layout , EDA & Simulations 1
moypen CST Studio - MHF4 connector Wireless & RF Design 0
C Looking for this male connector Power Electronics 1
Younes Thabet How to desolder a 100 pin connector? Technical Repair 7
W Surge Protection for 12v DC 5.5x2.1mm Barrel Connector Power Electronics 8
Similar threads
problem finding footprint for a connector in ALtium
CST Studio - MHF4 connector
Looking for this male connector
How to desolder a 100 pin connector?
Surge Protection for 12v DC 5.5x2.1mm Barrel Connector

You May Also Like

Top