All About Circuits

Scaling down the SPI0 clock value on RPi 3B+/4B

E

Thread Starter

electrophile

Joined Aug 30, 2013
167
I have a custom STM32 MCU board that interfaces with an RPi 3B+ via the SPI protocol. The MCU (STM32F407) has its SPI peripheral clock set at 84MHz and is configured as a slave device. For reliable transmission, the Master (in this case, the RPi) needs to have its SPI clock at 1/2 value i.e, at 24MHz or lower (I read that it needs to be an even number). From what I understand the RPi's SPI clock runs at 250MHz. How can I scale down this clock value?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
S Auto-scaling an analog meter has accuracy problems Analog & Mixed-Signal Design 8
B Scaling filter capacity for stepper driver General Electronics Chat 3
D Scaling the output voltage in opamp circuit Analog & Mixed-Signal Design 14
SamR LTS Transformer and Scaling Oddity PCB Layout , EDA & Simulations 15
S Time operations on signals. e.g Time scaling, Time shifting of signal and Time reversal of a signal PCB Layout , EDA & Simulations 9
Similar threads
Auto-scaling an analog meter has accuracy problems
Scaling filter capacity for stepper driver
Scaling the output voltage in opamp circuit
LTS Transformer and Scaling Oddity
Time operations on signals. e.g Time scaling, Time shifting of signal and Time reversal of a signal

You May Also Like

Top