One is not better than the other. One can dissipate more power than the other.
One, you need to purchase 2000 pieces. The other, you can buy as many as you need.

I understand that it will be good no matter which one I choose. My main concern is whether the resistor type is good. Or do you recommend something else?

 

What do you mean by “resistor type”?
Are the two types different?

 

will it function well as a replacement for Z552

 

Z551/Z552 are 0.22 Ω emitter power resistors. The resistor provides a number of functions.

1. Limits the current through the power transistor
2. Raises the voltage on the emitter of the transistor, reducing the base-emitter bias voltage
3. Shifts the operation mode from Class-B towards Class-AB, reducing cross-over distortion
4. Provides negative feedback and temperature stability, improving linearity

3 W power rating is underrated. 5 W power is an improvement.

5 W power dissipation will occur with 5 A through a 0.2 Ω resistor, using the formula,
P = I x I x R

5 A into an 8 Ω speaker is 200 W.

In other words, the resistor has to dissipate 5 W when driving an 8 Ω speaker at 200 W.

Edit:
3.5 A into an 8 Ω speaker is 100 W
3.5 A into a 0.22 Ω resistor 2.7 W.
3 W resistor will work, 5 W gives extra headroom.

 

Thank you for the valuable information.
I'm adding a few items to my shopping list: https://www.digikey.com/en/products/detail/te-connectivity-passive-product/SQPW5R22J/2365728

 

We don't yet know which components caused the catastrophic failure. Our focus is on getting the LEFT channel working so that we can get some real live voltages. I am contemplating replacing Q551 in the LEFT channel as a first stab at it.

Q551 replaced with a new one, voltages unchanged:
E: -6
C: -3,7
B: -5,3

 

I am running a circuit simulation and will get back to you if I find something.

 

I am running a circuit simulation and will get back to you if I find something.

Hello MrChips, did you find anything? I'd like to get it repaired, but I don't know what to check next. I will be grateful for any suggestions

 

Hello MrChips, did you find anything? I'd like to get it repaired, but I don't know what to check next. I will be grateful for any suggestions

Sorry I got distracted by other things. I don't know when I will be able to get back on this but I haven't given up.

 

Sorry I got distracted by other things. I don't know when I will be able to get back on this but I haven't given up.

Ok, I understand you. In that case, I'm waiting for a message from you.

 

For reference only, I am looking at the circuit for the LEFT channel. (Of course, the RIGHT channel will be identical.)
I cannot get the simulator to arrive at the same voltages as shown in the service manual below.



I don't understand what IC501, Q501, Q503, Q505, Q507 do.

Output stage Q553, Q555, Q557, Q559 is a classic configuration. Q551 is the driver stage but I don't see how it gets biased properly.

There is feedback from (a) via R573 (1-ohm) to zener diodes D501 and D503. On the simulator, this feedback is going to drive the Q501 and Q503 outputs which are the supply voltages of IC501. Thus, IC501 supply voltages change with signal content.

I am inclined to ignore IC501, at least for a test.
What are the voltages at TP401 (1) (2) and (3) ?