Hi.
Have found this online and have modified it a little.
As far as i can see the function is.
When pust on "S1" the state out of "IC1B" change from 0v to 12v. ?
And by this i can feed an transistor that "pull" my relay ? Coil 390 Ohm
And when i press button again it change state back to 0 v ?
Just to be clear ,
And the Resistor R3 ? is value ok ?
Rgds
Sten
Have found this online and have modified it a little.
As far as i can see the function is.
When pust on "S1" the state out of "IC1B" change from 0v to 12v. ?
And by this i can feed an transistor that "pull" my relay ? Coil 390 Ohm
And when i press button again it change state back to 0 v ?
Just to be clear ,
And the Resistor R3 ? is value ok ?
Rgds
Sten
Attachments
-
10.3 KB Views: 31