Hi, I just have finished a single sided PCB, it is going to be used in an audio proyect and I just wanted to read some opinions. The PCB has four Jumpers J1, J2, J3 and J4
I know that a bad routing can damage the integrity of the signals but I don't know the techniques to avoid that.
This is the PCB without the ground plane (So you can look at the tracks)
This is the track of the ground
And this is the track of the source
This is the PCB with ground plane
Also.. ¿should the ground plane be on both sides? or just at the bottom layer(the blue one)?
I know that a bad routing can damage the integrity of the signals but I don't know the techniques to avoid that.
This is the PCB without the ground plane (So you can look at the tracks)
This is the track of the ground
And this is the track of the source
This is the PCB with ground plane
Also.. ¿should the ground plane be on both sides? or just at the bottom layer(the blue one)?
Attachments
-
136.5 KB Views: 53
-
118.1 KB Views: 53
-
115.3 KB Views: 52
-
141.9 KB Views: 53