Hello all,
Im having trouble switching my mosfet with an arduino within my asymmetrical h bridge. I had it working with an 8 channel relay and switched to a faster isolated switching device, (Dual high power mosfet trigger switch drive module (5v - 36V) 15A). I believe it's because my winding line and source is on the same line, which is reducing the voltage. I was able to get it to switch on my first pcb design then it stopped working (possibly because I damaged the switch mode power supply), but now I got a new switch mode power supply and re did the circuit to make it clear and more drawn out. The second pcb just locks the motor and just melts the source to arduino wires. The arduino is supposed to switch the mosfet on for 3 seconds and then off for 1 second.
Im having trouble switching my mosfet with an arduino within my asymmetrical h bridge. I had it working with an 8 channel relay and switched to a faster isolated switching device, (Dual high power mosfet trigger switch drive module (5v - 36V) 15A). I believe it's because my winding line and source is on the same line, which is reducing the voltage. I was able to get it to switch on my first pcb design then it stopped working (possibly because I damaged the switch mode power supply), but now I got a new switch mode power supply and re did the circuit to make it clear and more drawn out. The second pcb just locks the motor and just melts the source to arduino wires. The arduino is supposed to switch the mosfet on for 3 seconds and then off for 1 second.