When you buy a “consumer unit” it comes with a copper bar like this, which joins all the MCBs together.The only "miniature" circuit breakers that I have used have indeed been snapped onto Din rails in control panels. Because they are WIRED on both supply and load side they are not at all suitable for application in a distribution panel at all, at least where I live. Distribution panel breakers are fed off of a bus-bar, which is protected by a Main Circuit Breaker, always with a greater current rating.
So the type of breaker utilized depends greatly on the application, at least where some regulations apply. And still, not calling them BRANCH circuit breakers, relating to the application, makes a lot more sense to me.
There are versions with two and three bars, and insulation between them which connect every other, or every third breaker to a common live.

It's also a very handy piece of copper if you want to put a high current bus on a pcb! The 18mm spacing is just about right for TO220 transistors.