Hi,

I'm looking to start getting back to FPGA programming. The only experience I have is designing traffic light sequence a few years ago but now I'm looking to try it again. I was wondering if anyone have learned form online tutorials that you can recommend and if you've worked with a development board which one did you get and why? I've read reviews of mojo V3, and older boards like mimas v2, elbert v2.

Thanks,
-f

 

I am a beginner in FPGA. I used Digilent's Atlys FPGA board to implement some simple logics. Xilinx is used to synthesize and Adept software for uploading the bit file to the board.
The following links may be helpful for you
1. http://www.asic-world.com/verilog/index.html
2. https://docs.numato.com/kb/learning-fpga-verilog-beginners-guide-part-1-introduction/

 

https://embeddedmicro.com/mojo-v3.html

I have been using the embedded micro mojo. It's an excellent little board and they also have a good set of tutorials so that you can get up to speed quickly. I was able to provide a demo to someone in about two days for a job interview.