Hello guys , How do I convert a 50mV signal to volts without any clipping. My design is as shown below.
Here is how I proceeded
1)I DC biased my amplifier so that Vce is 9.3 V
2) I assumed a 2mA collector current at Q point
3) The values of Rc and Re were then calculated
4) From the resulting voltage Ve, Vb= Ve+0.6 V and the ratio of resistor R1 and R2 was calculated.
The only problem is that the amplifier goes to saturation , I want to input signals of around 50mV and get an output around 5V pk-pk.How can I modify my circuit?
Here is how I proceeded
1)I DC biased my amplifier so that Vce is 9.3 V
2) I assumed a 2mA collector current at Q point
3) The values of Rc and Re were then calculated
4) From the resulting voltage Ve, Vb= Ve+0.6 V and the ratio of resistor R1 and R2 was calculated.
The only problem is that the amplifier goes to saturation , I want to input signals of around 50mV and get an output around 5V pk-pk.How can I modify my circuit?
Last edited: