How to measure an inductance

neonstrobe

Joined May 15, 2009
200
I don't know what target inductance you needed, but I certainly would not use a bolt. One of the earlier posts mentioned that a bolt will give a poor result. In that case the effective RL will load the coil and give a low phase angle (instead of 90 degrees). So my advice would be to determine what inductance you need; decide if you could use air core, ferrite core or iron, then obtain a suitable core. If using a lot of turns the self-capacitance can be reduced by using old-fashioned layering (not the " free winding" of modern power transformers) and using fairly thick insulation sheets between layers. I've wound successful MW IF air cored coils that were so consistent that the three units resonated at the same frequency with the same capacitance values (presumably these were fairly well matched too) and although I fitted variables they were all set to the same value!
 

neonstrobe

Joined May 15, 2009
200
I also seem to get the maths to work out correctly. I prefer using Z when there is an impedance involved.
the total impedance is then Z=sqrt(R^2+(2pifL)^2) where R=sum of external and internal resistances R1+RL.
The voltage across the inductor V1 is then its impedance x current
V1=sqrt(RL^2 + (2pifL)^2) x Vt/(sqrt(R^2+(2pifL)^2)
which eventually gives
L=1/(2pif).sqrt{[(V1.R)^2-(Vt.RL)^2]/(Vt^2-V1^2)}
but if the core loads the inductor the sums don't work because that adds another (unknown) resistor in parallel with the coil, which will only be found by measurement.
 

Thread Starter

Wendy

Joined Mar 24, 2008
23,869
Except at the time I could not get it to work I think that this was because I was trying to measure voltage across the inductor when I should have focused on using the measuring voltage acros the resistor instead. A subtle but important difference.

Just so you know I am recovering from a stroke, which is hindering me enormously doing anything like bench wok.
 
Top