Hello everyone!
I need to delay a signal to use as the control signal for a full-bridge inverter, so that the original signal controls one half of the H bridge and the delayed signal controls the other half, creating a modified sine wave output.
I cannot figure out a way to delay this signal. I will be using a sine wave and then I will send it through an comparator op amp to create a square wave to control the switches. I need to delay this signal at either of these stages, depending on which is easier to delay (a sine wave or a square wave).
What would be the easiest way to do this, without the need for computer programming or anything like that?
Thank you!
I need to delay a signal to use as the control signal for a full-bridge inverter, so that the original signal controls one half of the H bridge and the delayed signal controls the other half, creating a modified sine wave output.
I cannot figure out a way to delay this signal. I will be using a sine wave and then I will send it through an comparator op amp to create a square wave to control the switches. I need to delay this signal at either of these stages, depending on which is easier to delay (a sine wave or a square wave).
What would be the easiest way to do this, without the need for computer programming or anything like that?
Thank you!