I am going to replace the input capacitors on the 12 volt side.
They are currently some cheap china brand and are 3300 uf 16v.
I will definetly up the voltage to like 24 vdc. There 12 of these.
Would increasing the 3300uf to a higher value help with surge or be worth doing?
I have seen where some people are putting a farad or more on the DC wires going into the inverter to help with surge starts. Although if they are wider they might not fit the board. They can easily go taller about 1/2 inch. Right now they are about 1.25 inch tall and 1/2 inch wide.
They are currently some cheap china brand and are 3300 uf 16v.
I will definetly up the voltage to like 24 vdc. There 12 of these.
Would increasing the 3300uf to a higher value help with surge or be worth doing?
I have seen where some people are putting a farad or more on the DC wires going into the inverter to help with surge starts. Although if they are wider they might not fit the board. They can easily go taller about 1/2 inch. Right now they are about 1.25 inch tall and 1/2 inch wide.