Hi, this is my first post so, please advise if something is wrong.
I have 4 x 300W power supplies to wire up to 4 dev boards to drive some speakers.
my plan is to run from one plug to function box then out to the 4 power supplies. They are 24V 12.5A output. Each power supply goes to one dev board. My issue is connecting from the power supply output to the board. I need to use a 5.2mm dc jack but the ones we have can only take very small wires, barely fits 2 x 1mm2 with some force. But to my understanding I need to use 2.5mm2 to handle the 12.5A current.
Am I able to use thinner wire?
Are there different jacks I could use without using the quick connect screw type ones?
Thanks in advance.
I have 4 x 300W power supplies to wire up to 4 dev boards to drive some speakers.
my plan is to run from one plug to function box then out to the 4 power supplies. They are 24V 12.5A output. Each power supply goes to one dev board. My issue is connecting from the power supply output to the board. I need to use a 5.2mm dc jack but the ones we have can only take very small wires, barely fits 2 x 1mm2 with some force. But to my understanding I need to use 2.5mm2 to handle the 12.5A current.
Am I able to use thinner wire?
Are there different jacks I could use without using the quick connect screw type ones?
Thanks in advance.