Control Stepper motor by USB type C

dendad

Joined Feb 20, 2016
4,451
What controlling program are you wanting to run on the PC?
Will it just be a serial terminal or what?
A lot more info is really required.

Most 3D printers allow you to control their steppers via USB. The older ones are Arduino based.
Maybe you could start that way, an Arduino 2560 and RAMPS card can be purchased quite cheaply on Ebay.
 

Thread Starter

Назар Мельнічек

Joined Jan 16, 2019
11
What controlling program are you wanting to run on the PC?
Will it just be a serial terminal or what?
A lot more info is really required.

Most 3D printers allow you to control their steppers via USB. The older ones are Arduino based.
Maybe you could start that way, an Arduino 2560 and RAMPS card can be purchased quite cheaply on Ebay.
I do not want use Arduino, I want use stm32 or psoc5 (cypress semiconductor).
 

danadak

Joined Mar 10, 2018
4,057
Top