- Joined Jan 16, 2019
I want control stepper motor by USB type C, who can recommend main processor and driver?
I do not want use Arduino, I want use stm32 or psoc5 (cypress semiconductor).What controlling program are you wanting to run on the PC?
Will it just be a serial terminal or what?
A lot more info is really required.
Most 3D printers allow you to control their steppers via USB. The older ones are Arduino based.
Maybe you could start that way, an Arduino 2560 and RAMPS card can be purchased quite cheaply on Ebay.
Hi Dana, thank you very much for your help!
I would post your description of design and this question on Cypress PSOC
|Thread starter||Similar threads||Forum||Replies||Date|
|Using WeMos D1 mini and DRV8825 to control bipolar stepper motor over Wi-Fi via Blynk app||Microcontrollers||1|
|S||Help in creating a system to control a stepper motor + drive manually, to move a machine on rails linearly||General Electronics Chat||29|
|S||Control Stepper Motor with TD-2M33 Driver||General Electronics Chat||1|
|C||Stepper motor control wiring||Homework Help||4|
|M||Need help on this device Dc 5v 4-phase 5 wire stepper motor board + remote control||General Electronics Chat||1|
|Using WeMos D1 mini and DRV8825 to control bipolar stepper motor over Wi-Fi via Blynk app|
|Help in creating a system to control a stepper motor + drive manually, to move a machine on rails linearly|
|Control Stepper Motor with TD-2M33 Driver|
|Stepper motor control wiring|
|Need help on this device Dc 5v 4-phase 5 wire stepper motor board + remote control|
by Jake Hertz
by Jake Hertz
by Luke James