Hi! I am working on switching of MOSFET. I tried to run the mosfet in half bridge configuration. The simulation got stuck at 0.4%. I am switching the mosfet at 100 kHz frequency. I was able to drive the mosfet alone (in boost converter circuit). But when I tried to drive the mosfet in half bridge configuration, I could not run it. The gate driver I am using is ACPL 337J (Datasheet- https://www.mouser.com/datasheet/2/678/V02-4390EN_DS_ACPL-337J_2014-05-09-909393.pdf). The mosfet I am using is STF27N60M2-ep (Datasheet- https://www.st.com/resource/en/datasheet/stf27n60m2-ep.pdf). The schematic of boost converter circuit is -
Please find the attached schematic (LTspice) of boost converter circuit (Draft 29).
I implemented this circuit in half bridge configuration.-
Please find the attached schematic of half bridge configuration (Draft 30).
Please help me pointing out where I am doing it wrong. Also please upload the corrected schematic.
Please find the attached library of mosfet.
Please find the attached schematic (LTspice) of boost converter circuit (Draft 29).
I implemented this circuit in half bridge configuration.-
Please find the attached schematic of half bridge configuration (Draft 30).
Please help me pointing out where I am doing it wrong. Also please upload the corrected schematic.
Please find the attached library of mosfet.
Attachments
-
4.8 KB Views: 4
-
8.7 KB Views: 3
-
6.6 KB Views: 9