Good day people.
I've got some problem doing one of my project.
And here goes,
I am building a touch base input device for my project. And basically i came up with this idea of using a window comparator for the application.
The list of component used:
- touchpad (is basically a copper tracing which is a open circuit at first, refer to figure 1)
- LM741 op-amp x 2pcs
- 1kohm resistor x 2pcs
- zener diode x 2pcs
- 7408 AND GATE x 1pcs
The result i wanted was that once i touch the touchpad, the output from the AND GATE must be a logic 1 and once i let go, it ouput must be a logic 0. (im comparing 6v and 1v respectively n' not 5v and 1v)
And i tried quite a number of method to no avail.
Am really quite stuck down by it.
Any help would be grately appreciated
figure 1: the touchpad
figure 2: before implementing the touchpad to the window comparator
figure 3: added in the touchpad to the comparator circuit
THANK YOU
I've got some problem doing one of my project.
And here goes,
I am building a touch base input device for my project. And basically i came up with this idea of using a window comparator for the application.
The list of component used:
- touchpad (is basically a copper tracing which is a open circuit at first, refer to figure 1)
- LM741 op-amp x 2pcs
- 1kohm resistor x 2pcs
- zener diode x 2pcs
- 7408 AND GATE x 1pcs
The result i wanted was that once i touch the touchpad, the output from the AND GATE must be a logic 1 and once i let go, it ouput must be a logic 0. (im comparing 6v and 1v respectively n' not 5v and 1v)
And i tried quite a number of method to no avail.
Am really quite stuck down by it.
Any help would be grately appreciated
figure 1: the touchpad
figure 2: before implementing the touchpad to the window comparator
figure 3: added in the touchpad to the comparator circuit
THANK YOU
