I just put a 16F886 in a new 830 hole BPS breadboard.
Good thing I remembered to push a jumper through every hole where it went.
I could hardly get the jumper pin into most of the holes!
If you like bending IC pins go ahead and just put your IC's in a BPS breadboard before doing this.
That's the long and short of it.
Like Bartles and James 'Thank you for your support!'
Good thing I remembered to push a jumper through every hole where it went.
I could hardly get the jumper pin into most of the holes!
If you like bending IC pins go ahead and just put your IC's in a BPS breadboard before doing this.
That's the long and short of it.
Like Bartles and James 'Thank you for your support!'
Last edited: