All About Circuits

ARDUINO GT-511C3 FINGER HEX VALUE READ

AJIN NADH

Thread Starter

AJIN NADH

Joined Dec 18, 2014
84
Hi all,
I am using GT-511C3 to read the finger print value using arduino, is any way to read the value as hex,....?


Regards,
Ajin nadh v a
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
T Pressure sensor in flowmeter is accurate but not consistent Sensor Design & Implementation 0
firashelou How to stop a timer delay using millis() from executing with NRF24L01 Network (Arduino) Microcontrollers 8
V Arduino i2c communication hangs while running motor General Electronics Chat 2
T Differential Pressure Sensor zero error constantly moving Sensor Design & Implementation 13
B Arduino to Airsoft Gun interface Critique General Electronics Chat 5
Similar threads
Pressure sensor in flowmeter is accurate but not consistent
How to stop a timer delay using millis() from executing with NRF24L01 Network (Arduino)
Arduino i2c communication hangs while running motor
Differential Pressure Sensor zero error constantly moving
Arduino to Airsoft Gun interface Critique

You May Also Like

Top