That makes sense, but is clipping important for an inductive load in this case? Especially if it's just being used for isolation? Also, how does using a Zener in the flyback circuit affect the secondary voltage versus just a single diode, if at all?
Hm, to me it seems kind of pointless to have a Zener on just for heat dissipation, especially when it's only on a 12V circuit. If that's all it's for I could get rid of it without causing harm, correct?D2 aids in ending the snub current by converting it to heat and dissipating it.
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
| B | Repurpose a Smart TV | General Electronics Chat | 8 | |
|
|
Checking zener diodes | General Electronics Chat | 18 | |
|
|
Bypass capacitor purpose? | Analog & Mixed-Signal Design | 31 | |
| S | Oscilator circuits -Zener's voltage & potentiometer's Ohm | General Electronics Chat | 4 | |
| D | Microwave Oven Control Panel Re-purposed | Technical Repair | 37 |