Hi
I'm working on my board and today after assembling some components on it, I ran it and unfortunately sounds like some components burnt out. it's a question to me what cause these problems. this is the schematic:
And PCB:
Also I think one problem is that I have designed two 3v3 LDO for this board to have enough current. I think that was not a good idea. Is there any other problem/mistake in your opinion?
I'm working on my board and today after assembling some components on it, I ran it and unfortunately sounds like some components burnt out. it's a question to me what cause these problems. this is the schematic:
And PCB:
Also I think one problem is that I have designed two 3v3 LDO for this board to have enough current. I think that was not a good idea. Is there any other problem/mistake in your opinion?