I will be driving a few lamps, just a small 12v 30 to 100milli-amp max. I had thought of using the same Logic level fets I am using for my H-Bridge as the drivers, they are IRLML2502 N Channel. If I use a 10K resistor on the drian tied to the plus rail I should be ok right ?
My thinking behind using Fets is once again like the H-Bridge, don't need to use any pull-up/down resistors on the gate so it makes everything simple.
the PIC is 16F seriers running at 5V. the Drian of the Fet connects to a 12v rail that also supplies the H-Bridge. Everything has a common ground.
My thinking behind using Fets is once again like the H-Bridge, don't need to use any pull-up/down resistors on the gate so it makes everything simple.
the PIC is 16F seriers running at 5V. the Drian of the Fet connects to a 12v rail that also supplies the H-Bridge. Everything has a common ground.