I have a question that I wanted to post to the forum regarding whether it best to use a mosfet or NPN transistor to switch a voltage to ground.
I was looking to take a pulsed 13VOLT signal and have the ability to send this signal to ground in effect stopping the signal.
Is it better to use a NPN transistor or a N channel mosfet?
I would be switching 13VOLTS
at 10 amps. The base or gate would be controlled with 0v-5v logic.
Thank you
Val
I was looking to take a pulsed 13VOLT signal and have the ability to send this signal to ground in effect stopping the signal.
Is it better to use a NPN transistor or a N channel mosfet?
I would be switching 13VOLTS
at 10 amps. The base or gate would be controlled with 0v-5v logic.
Thank you
Val