Sorry to hear that my friend.
No apology required. We will continue when you are well again. Take all the time you need.

Hi, finally I feel better, still got headache but less then before and I'm testing negative! I have install the components, diode and transistor, not test it as I prefer doing it under your supervisor, when you ready i'm ready...I have 3 hours free now or this evening after 8pm! Or when you can ciao

 

I'm available now or can wait till later. 8 pm your time is 1 pm here, you decide.

 

I'm available now or can wait till later. 8 pm your time is 1 pm here, you decide.

Hi bro, sorry i seen this now, I come back little bit later, if you r available, we con do now

 

Now is fine.

 

Now is fine.

ok, thank you

 

Are you confident the new components are installed correctly?

 

Are you confident the new components are installed correctly?

Yes I do

 

OK then, time to turn the amp ON.

 

OK then, time to turn the amp ON.

ok finger cross

 

ok finger cross

I have the click, but the speaker are not connected, let me try connect it and let you know

 

I have the click, but the speaker are not connected, let me try connect it and let you know

My friend, you are a genius!!! All woking but i don't have the small board connected

 

My friend, you are a genius!!! All woking but i don't have the small board connected

it click after few second has it should be

 

Great news!
Did you get a replacement chip for the small board?

 

Great news!
Did you get a replacement chip for the small board?

No my friend, I realise that was coming from abroad and I cancel the order! Than I get covid and I completely forgot about it! I can buy it, is not a problem, we can procede when I got it

 

Give a few minutes to pull up the schematic. There may be a few things we can check before ordering.

 

No my friend, I realise that was coming from abroad and I cancel the order! Than I get covid and I completely forgot about it! I can buy is not a problem, we can procede when I got it

Give a few minutes to pull up the schematic. There may be a few things we can check before ordering.

No problem, take all the time you need!!

 

OK.
Do this without the board connected in the amp.
Connect the negative lead of the meter on pins 9 and 10. Those two pins are connected together and are the ground connection for that board. Set meter for DIODE
Take the positive lead and get readings on pins 1 and pin 2.

 

No problem, take all the time you need!!

honestly, I don't know how to thank you

OK.
Do this without the board connected in the amp.
Connect the negative lead of the meter on pins 9 and 10. Those two pins are connected together and are the ground connection for that board. Set meter for DIODE
Take the positive lead and get readings on pins 1 and pin 2.

ok

 

honestly, I don't know how to thank you

ok

are you sure in diode mode? If so, nothing happen

 

You mean there was no reading as if the leads were not even connected?