I've applied flux on both sides and pressed it on soldered joints but the wick is not absorbing.
I'm doing this for the build it yourself RTL-SDR project, I need to remove the USB connector, IR sensor or LED and antenna connector from the dongle, I've managed to remove antenna connector with suction tube but I'm unable to do it for IR sensor or LED and USB connector, the wick is just not absorbing.
I'm doing this for the build it yourself RTL-SDR project, I need to remove the USB connector, IR sensor or LED and antenna connector from the dongle, I've managed to remove antenna connector with suction tube but I'm unable to do it for IR sensor or LED and USB connector, the wick is just not absorbing.