Hey all,
I'm currently working on a project using logic gates to trigger LEDs, relays etc.
I am supposed to use series 74 TTL so im assuming that means 74LS opposed to 74HCT as its CMOS.
for my circuit i've only got leds feed off the gates and the rest off transistors due to the high current.
My question is what are the general sink and source currents of 74LS gates. I'll be using basic gates such as quad 2-input and, or gates and hex inverter.
I've got a basic understanding of the different between sink and source. source is getting voltage from gate at "1" and then earthing. while sink is seperate voltage and earthing at gate when its "0".
i've got mixed answers such as they source 15 - 25 mA and only sink 0.4 mA or that they sink up to 16mA but they can source only about 2mA
Looking at the 74LS datasheets i believe that sink current is Iol and source is Ioh. If datasheets are right that means 74LS can handle more sink current than source current. If so does that mean i should really be connecting my LEDs in sink instead of source?
Expert knowledge in this field would be much appreciated and thank you in advance
Cruizerdog
I'm currently working on a project using logic gates to trigger LEDs, relays etc.
I am supposed to use series 74 TTL so im assuming that means 74LS opposed to 74HCT as its CMOS.
for my circuit i've only got leds feed off the gates and the rest off transistors due to the high current.
My question is what are the general sink and source currents of 74LS gates. I'll be using basic gates such as quad 2-input and, or gates and hex inverter.
I've got a basic understanding of the different between sink and source. source is getting voltage from gate at "1" and then earthing. while sink is seperate voltage and earthing at gate when its "0".
i've got mixed answers such as they source 15 - 25 mA and only sink 0.4 mA or that they sink up to 16mA but they can source only about 2mA
Looking at the 74LS datasheets i believe that sink current is Iol and source is Ioh. If datasheets are right that means 74LS can handle more sink current than source current. If so does that mean i should really be connecting my LEDs in sink instead of source?
Expert knowledge in this field would be much appreciated and thank you in advance
Cruizerdog