Is there any chance for this schematic to work propperly? New to Easy Eda while trying to make a pcb design for a drone, going to add motors and speed controllers,

 

Not a chance.

 

any other solutions?

 

01001001 00100000 01110101 01101110 01100100 01100101 01110010 01110011 01110100 01100001 01101110 01100100 00100000 01100010 01101001 01101110 01100001 01110010 01111001

 

Is there any chance for this schematic to work propperly?

What is it supposed to do? Hence, no chance it will work.

As for other options? For doing what?

As for,

01001001 00100000 01110101 01101110 01100100 01100101 01110010 01110011 01110100 01100001 01101110 01100100 00100000 01100010 01101001 01101110 01100001 01110010 01111001

That will not help you get a reply from me. I understand binary too.

 

Welcome to AAC!
Unless you tell us exactly what your circuit is intended to do, and include all of it, there is no way we can know if it will work properly.

 

01001001 00100000 01110101 01101110 01100100 01100101 01110010 01110011 01110100 01100001 01101110 01100100 00100000 01100010 01101001 01101110 01100001 01110010 01111001

Not enough, in my opinion.

 

Can not read the text. Right hand side, two caps C16 & C1? probably should connect to ground. I don't see the red dot.

 

sorry for not being specific, The Schematic is for a coaxial helicopter not a drone, the plan is to replace the broken pcb and make a new one with SX1278 LORA transceiver, Neo-6M-GPS, MPU6050. The plan is that it´s going to be based on the atmel328p, and that it can easily be programmed with a FTDI driver, the coaxial helicopter uses three motors: two 3.7V DC 45000RPM(Main motor 1 & 2) and one 3.7V DC 66000RPM for the tail. The tail motor has to spin in both directions for reverse and forward, so I were trying to add a H bridge but the package seem to be to large, the ideal package on the components should be 0402. If someone could help me figure out what kind of transistors I should have and help me figure out a way to make the schematic work, that would be a sensation.(here's a updated picture with the H bridge and the "motor control circuit".

 

Update: I am changing the Neo-6M-GPS to a Quectel L80-R because of the package and the built-in antenna if that is possible.

 

Schematic for drone, hmmm, actually I have been in contacts long enough with two drone producers, one was doctor-student from Germany telling an exalted referate serie on his 6 year job results on AI system for drones, elaborating in his Doctor dissertation, and he was even not near to stable and well sliffed system. Other is our national company where 3 aviation experts with 50 year expertize in airflight from Riga airport came together with about dozen highest level programmers and after 8 years of efforts and just seconds before full bankrupt when flight-model was ready for 99% but all money run away up to the whole family belongings are under the hammer, they escape by Common Funding and now them have an USA company producing and selling those robotized machines in millions exemplar yearly. Do You as honourable author feels You more mighty as those both mentioned guys? Then You are genious indeed, I envy. If not, just buy up the ready parts with well known software and dont waste Your life for Sizifian labor (hope know that antique Greek personage, what he did).