Protect Li-Ion overcharge/overdischarge

Thread Starter

maytere

Joined Jun 21, 2012
2
Hi. This is the schematic of my module;
xtp4056-breakout-boad-schematic-enh.jpg.pagespeed.ic.Gl_BvpPGXc.jpg

If i short out+ and out-, DW01A does its job and opens output. But if i connect a screwdriver motor to out+ and out- module breaksdown and I am measuring 1.42V at DW01A CS pin. I think 8205A burns.
What may cause this? If motor current is more than 8205A maximum current why it doesnt burn when I short outputs?
Thanks.
 
Top