Facebook
Google
GitHub
Linkedin
Hi@william.in.rs
Did you solve your problem?
Did you solve your problem?
Protect Li-Ion overcharge/overdischarge
- Thread starter maytere
- Start date
hi,
New Thread for this TS
Mod:Link to old thread:
https://forum.allaboutcircuits.com/...ischarge-protection-board.149697/post-1280929
New Thread for this TS
Mod:Link to old thread:
https://forum.allaboutcircuits.com/...ischarge-protection-board.149697/post-1280929
Hi. This is the schematic of my module;
If i short out+ and out-, DW01A does its job and opens output. But if i connect a screwdriver motor to out+ and out- module breaksdown and I am measuring 1.42V at DW01A CS pin. I think 8205A burns.
What may cause this? If motor current is more than 8205A maximum current why it doesnt burn when I short outputs?
Thanks.
If i short out+ and out-, DW01A does its job and opens output. But if i connect a screwdriver motor to out+ and out- module breaksdown and I am measuring 1.42V at DW01A CS pin. I think 8205A burns.
What may cause this? If motor current is more than 8205A maximum current why it doesnt burn when I short outputs?
Thanks.
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
| B | reverse polarity protect with gnd | Analog & Mixed-Signal Design | 5 | |
| E | Zener used to protect switching node pin? | Power Electronics | 2 | |
| G | How to protect buck converters | Power Electronics | 7 | |
|
Protect TIA | Homework Help | 6 | |
| W | Protect Li-Ion overcharge/overdischarge protection board | Power Electronics | 8 |
