All About Circuits

Paneling different Proteus .GBR files into a single panel

Search Forums New Posts
J

Thread Starter

JakeQuinn

Joined Jan 31, 2020
1
I have multiple project made from proteus 8.9 and i want to panel them into a single board with breakable/cut tab connecting them. The problem is that there seems to be very few programs that can do this.

I have tried using this guide but upon adding my file it would not show anything in the viewport. I would assume that the problem is the naming scheme of the .gbr files

Capture.JPG

Is there anyway to convert these files to the old gerber format? Or a program that can panelize different design board from proteus gerber files?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
E Different IR2184 behavior when driven from Arduino D9 vs D10 General Electronics Chat 17
Externet Why different voltages ? General Electronics Chat 2
Ya’akov Things are... different than they used to be. Off-Topic 5
P Need to modify a circuit to measure continuity under different conditions. Analog & Mixed-Signal Design 3
E choosing the right debug tool for different embedded failures Microcontrollers 3
Similar threads
Different IR2184 behavior when driven from Arduino D9 vs D10
Why different voltages ?
Things are... different than they used to be.
Need to modify a circuit to measure continuity under different conditions.
choosing the right debug tool for different embedded failures

You May Also Like

Top