NICE gate remote connected to car battery got fried

Thread Starter

Jahnlee

Joined Jul 2, 2015
64
With those types of transmitters simple single piece of wire will work rather well as an antenna although given the largely plastic and composite materials that a vehicle dash is made of the odds are it won't need one anyway. Especially so if you are only needing to transmit a few tens of feet at best.
Yes, I put the remote underneath the steering column and was able to activate the gate. Good stuff!
 

Thread Starter

Jahnlee

Joined Jul 2, 2015
64
Your welcome on the remote recovery.

In any event, you can probably take a piece of Coax like RG174 and expose the end (remove the shield only), but try it with no wire first.
Looking good after a few tries. The test is how long it can last before it hangs like before. I've put in spare holes to mount the TVS if needed as I couldn't get hold of it in time before I boxed it up.
 

Thread Starter

Jahnlee

Joined Jul 2, 2015
64
Basically, yes but I have to say that I do not like switching the power like that.

I agree with tcmtech about adding a capacitor across the zener but would limit it to 220 - 470uF and best to use a 25V or more electrolytic.
Graham
I eventually mounted a 1000uF cap because it's smaller but could you help explain why limit it to 220-470uF? Is it to prevent too high a discharge current to the remote and is the discharge current dependent on the impedance of the remote? The remote is drawing approx. 17mA.

I also wired it to the accessory instead of straight to the battery feed. If I wired it direct, apart from parasitic drain, are there are issues? I am using a 5W 12V zener and a 0.5W 50 Ohm resistor.
 

NCSailor

Joined Jun 15, 2013
33
I eventually mounted a 1000uF cap because it's smaller but could you help explain why limit it to 220-470uF? ...

I also wired it to the accessory instead of straight to the battery feed. If I wired it direct, apart from parasitic drain, are there are issues? ....
Glad it is working for you.

No problem with the capacitor. I probably could have just said that there is no real advantage for your circuit with more than 220-470uF. Normally these would have been smaller and cheaper than some of the higher suggestions.

It is usually considered better practice to use the accessory circuit for devices like this where practical. The battery circuit will see higher variations in voltage as it is exposed to starter motor loads, connect/disconnect, jump start, etc. Either way should work fine and cause no problems as long as you have included a small fuse in your wiring.

Graham
 
Top