I have the little audio fx board from adafruit. I'd like to make it's end of the job a little more permanent, leaving me the freedom to mix and match buttons and such on a bread board.
The pins are small. Can anyone provide a good place to start reading to learn about putting this sort of thing together? It came with the header pins in plastic that can be broken off to size. I'm also thinking my iron's tip is too large for this job.
https://www.adafruit.com/product/2133
There's a picture there against a US quarter to give it some scale.
The pins are small. Can anyone provide a good place to start reading to learn about putting this sort of thing together? It came with the header pins in plastic that can be broken off to size. I'm also thinking my iron's tip is too large for this job.
https://www.adafruit.com/product/2133
There's a picture there against a US quarter to give it some scale.