It's a PIC controller. The thing is tiny, minuscule ... almost microscopic ... it only measures 4x4mm, and has extremely close leads, only 0.65mm (0.026") spacing between them.
Other than good luck, any advice as to how it would be best to proceed? I'd like to use a soldering iron and avoid a heat gun. My main concern is not shorting the leads, but rather burning the thing while working on it.
Other than good luck, any advice as to how it would be best to proceed? I'd like to use a soldering iron and avoid a heat gun. My main concern is not shorting the leads, but rather burning the thing while working on it.