I'm having to design a BJT single stage amp for my electronics II class and can't get it even started.
The supply is suppose to be 14V
and the signal is 200mVp-p with rs=1.5k
The ouput is to be 6 Vp-p across a 47k ohm load
The lower cutoff freq has to be less than 35Hz while the upper cutoff freq must be between 50kHz and 200kHz
I have to use a 2N2222 trasistor: hfe=75
Anyone have any suggestions on how to go about getting this done?
Thanks in advance.
The supply is suppose to be 14V
and the signal is 200mVp-p with rs=1.5k
The ouput is to be 6 Vp-p across a 47k ohm load
The lower cutoff freq has to be less than 35Hz while the upper cutoff freq must be between 50kHz and 200kHz
I have to use a 2N2222 trasistor: hfe=75
Anyone have any suggestions on how to go about getting this done?
Thanks in advance.
Last edited: