I have a problem in my ET212 class that I truly have no idea on where to start, I have the circuit design, but am clueless when it comes to the values that I need to use. I am not asking for answers, mainly just guidance on where I am supposed to start, or the steps i need to do to find my answers.
Project details are 250mV peak input voltage, 20-20k Hz range, 8.4W power output 8 ohm load. I just have no idea where to start with analyzing and figuring out what capacitors or resistors I need to use. I know that I (probably) need to start with getting the voltage gain set for each transistor, but the darlington pair i dont understand well. The circuit design is below, any help is greatly appreciated. The 1k ohm and 1uF values are placeholders, as well as the VCC value.
Project details are 250mV peak input voltage, 20-20k Hz range, 8.4W power output 8 ohm load. I just have no idea where to start with analyzing and figuring out what capacitors or resistors I need to use. I know that I (probably) need to start with getting the voltage gain set for each transistor, but the darlington pair i dont understand well. The circuit design is below, any help is greatly appreciated. The 1k ohm and 1uF values are placeholders, as well as the VCC value.