mrf454 transistor setup.

Reply to Thread

Discussion in 'Wireless & RF Design' started by Donnie Lytton, May 10, 2016.

Reply to Thread
  1. May 10, 2016 #1
    Donnie Lytton

    Thread Starter New Member

    May 9, 2016
    3
    0
    i have a penetrater 200 bi linear which is a base unit.i have installed a pair of mrf454s but before it is power up what are the steps that must be done first like setting the bias voltage and so on.
     
    #1 Reply
Loading...
Related Forum Posts:
  1. dangky

    A very simple single npn transistor setup but doesn't work (pic included) ?

    Posted by dangky in forum: Analog & Mixed-Signal Design
    Replies:
    11
    Views:
    576
  2. guitardenver

    Obtaining Collector Current Vs lumens for photo transistor setup

    Posted by guitardenver in forum: Embedded Systems and Microcontrollers
    Replies:
    1
    Views:
    423
  3. guitardenver

    Obtaining Collector Current Vs lumens for photo transistor setup

    Posted by guitardenver in forum: General Electronics Chat
    Replies:
    16
    Views:
    1,182
  4. bwaley

    transistor

    Posted by bwaley in forum: General Electronics Chat
    Replies:
    6
    Views:
    1,427
  5. loue2

    Scoreboard Setup

    Posted by loue2 in forum: Embedded Systems and Microcontrollers
    Replies:
    0
    Views:
    1,786
You May Also Like:

  1. LED Dimming: A High-Power 40V Buck LED Driver with Two Dimming Methods from Diodes Incorporated

  2. Make an LED Light Strip AHRS with Arduino and MPU-6050

  3. World's Smallest MEMS Angular Acceleration Sensor


Load More Articles