Hi again folks! I've got my load cell feeding into a simple INA125P based circuit with an output range of about 1V to 4V. How could I get that output to light a series of leds? Like 1v lights 1 led, 1 1/2v 2 leds, 2 volts 3 leds, etc? Thanks so much.

 

Check out the LM3914 with the output configured as a bar display.
https://www.ti.com/lit/ds/symlink/lm3914.pdf

 

Thanks so much. That looks like it'll do the job.

 

Hello Steverod, it is good to hear that your INA125P based circuit is working well. There is another thread by "EZRA" who is not able to make their INA125P amplifier work correctly. Would it be possible for you to share what you have used with that person??

I do not normally do the "matchmaker role", but this makes a whole lot of sense to me.