Hi,
I think I've popped a PIC, but before I change it to a new one, is there a way to tell if it is working or not?
I couldn't get the Pickit3 connector to work properly, so I was removing the plastic pin separator with a screwdirver, to make a better contact, and didn't notice it was still connected to power, and one of the LEDs came on. (No program yet)
I've set the OSC to INT plus CLKO enabled, and programmed a simple LED flash program, but there's no CLK shown on the Oscilloscope.
Any ideas, please?
Camerart.
I think I've popped a PIC, but before I change it to a new one, is there a way to tell if it is working or not?
I couldn't get the Pickit3 connector to work properly, so I was removing the plastic pin separator with a screwdirver, to make a better contact, and didn't notice it was still connected to power, and one of the LEDs came on. (No program yet)
I've set the OSC to INT plus CLKO enabled, and programmed a simple LED flash program, but there's no CLK shown on the Oscilloscope.
Any ideas, please?
Camerart.