I am attempting to "make alive" a small B 17 model
Basically make propellers spin and have "standard" wigs lights plus "landing lights".... I am NOT looking for "military " look .
For controller I like to use my old "little wire".
It has these (attached) features to "drive I/O" hardware.
My question to the group
what hardware device to use to
1. set / reset "wings "LED lights
2. set / reset "landing" LED lights
3. independently "spin" each propeller,simulate
start and control speed
So far I like to use "Little wire" but obviously I need more PWM outputs.
Any suggestion for additional hardware would be appreciated.
Little Wire Features
Basically make propellers spin and have "standard" wigs lights plus "landing lights".... I am NOT looking for "military " look .
For controller I like to use my old "little wire".
It has these (attached) features to "drive I/O" hardware.
My question to the group
what hardware device to use to
1. set / reset "wings "LED lights
2. set / reset "landing" LED lights
3. independently "spin" each propeller,simulate
start and control speed
So far I like to use "Little wire" but obviously I need more PWM outputs.
Any suggestion for additional hardware would be appreciated.
Little Wire Features
- usbtinyisp compatible AVR programmer.
- 4 channel GPIO.
- ADC with 10 bit resolution.
- 2 parallel hardware PWM outputs.
- SPI interface.
- I2C interface.
- 1-Wire interface
- WS2812 RGB LED interface.
- Multiple device support.Littl;e wire
