Hello Mr Chips, I am very glad to see your discussion regarding the STM32F4, I am also a newbie to this and i am having too many problems.
1st one is i have installed the latest cubeMX and AtollicTrueStudio, i followed your discussion and i was able to run the code for blinking LED, it was good, But there are no guide or notes for learning programming syntax. As you wrote a condenesed code in one reply, that works pretty well but i could not understand it. i want to have enough understanding, that i can toggle a pin based on a condition, and i can chose any pin. but it seems to be difficult as i just started today.
2nd is i read online in many articles that using CubeMX is very user friendly, but i also cannot run a program using that as well, as i followed different tutorials but they were old and i am using a new controller STM32F407 with all latest softwares as of today.
So please if you could either guide me how can i directly program using TrueStudio or using CubeMX with truestudio.
1st one is i have installed the latest cubeMX and AtollicTrueStudio, i followed your discussion and i was able to run the code for blinking LED, it was good, But there are no guide or notes for learning programming syntax. As you wrote a condenesed code in one reply, that works pretty well but i could not understand it. i want to have enough understanding, that i can toggle a pin based on a condition, and i can chose any pin. but it seems to be difficult as i just started today.
2nd is i read online in many articles that using CubeMX is very user friendly, but i also cannot run a program using that as well, as i followed different tutorials but they were old and i am using a new controller STM32F407 with all latest softwares as of today.
So please if you could either guide me how can i directly program using TrueStudio or using CubeMX with truestudio.