Hi,
I have designed ESP12F with CH340G(USB- UART converter) with auto programming feature. As shown below. I have programmed in Arduino IDE. As long as power is there, the board runs the code. But After I cycle the power, the board doesn't run the program! until I hard reset the ESP12F. How can i avoid hard resetting and make the board work even afer I cycle the power !?
I have designed ESP12F with CH340G(USB- UART converter) with auto programming feature. As shown below. I have programmed in Arduino IDE. As long as power is there, the board runs the code. But After I cycle the power, the board doesn't run the program! until I hard reset the ESP12F. How can i avoid hard resetting and make the board work even afer I cycle the power !?
